Life Hack
How to make your pen work again☆
【Things you need】
If it’s for Permanent Marker
・nail polish remover
If it’s for Water-based pen
・Warm water
【Steps】
1)Put the cap of the pen into the nail polish remover. (Warm water for water-based pen)
※To Prevent from overflowing, do not use too much
2)Put the cap back on to the pen and wait for 10 min.
3)Pull the pen out. Be careful not to make a mess!
※If there are a lot of ink left, this tip will allow the pen to be functioned for a while, however if the ink left is not that many, this tip will only help for few minutes.
※Don’t forget to ventilate the room after using the nail polish remover.
Hope this tip helps☆
--------------------------------------------------------------------------
<How to Revive Ballpoint Pens with Masking Tape & Rubber Bands>
■Steps
1. Paste a rubber band at the center of a pen.
2. Grab both edges of a rubber band, twist and rotate a pen.
3. Twist it tight, pull both rubber edges. Dried ink is now getting back to the original!